Cabletron Systems RoamAbout Uživatelská příručka stáhnout pdf (Strana 38)

Installing the AP into a MultiSwitch 900 or DEChub 90

3-8 Installing Your Access Point

Installing the AP into a MultiSwitch 900 or DEChub 90

This section describes how to install the unit in a MultiSwitch 900 or DEChub 90.

Removing the Back Cover

If there is a cover on the back of the AP, you must remove it before inserting the AP

into the backplane. Perform the following steps to remove the back cover:

Step Action

1 Lift up the latch on the back cover by inserting a flat-blade screwdriver

into the top mounting hole, as shown in Figure 3-6.

Figure 3-6: Removing the Back Cover

2 With the latch up, pull the top of the back cover away, pivoting at the

bottom of the module.

LKG-6722-921-01

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 89 90

Žádné komentáře

Cabletron Systems RoamAbout Uživatelská příručka Strana 38