Cabletron Systems BRIM-E100 Uživatelská příručka stáhnout pdf (Strana 18)

BRIM-E100 User’s Guide Page 3-1

CHAPTER 3

INSTALLATION

This chapter contains instructions for unpacking the BRIM-E100,

installing Fast Ethernet Interface Modules, and installing the BRIM-E100

into Cabletron Systems devices that support BRIM technology.

The following equipment is needed to install the BRIM-E100 and Fast

Ethernet Interface Modules:

• 1 disposable grounding strap (provided with any MIM or hub)

• 1 Phillips screwdriver

3.1 UNPACKING THE BRIM-E100

Unpack the BRIM-E100 as follows:

1. Remove the shipping box material covering the BRIM-E100.

2. Carefully remove the module from the shipping box. Leave the

module in its non-conductive bag until you are ready to install.

3. Attach the disposable grounding strap to your wrist and to a proper

ground. Refer to the instructions outlined on the grounding strap

package.

4. After removing the module from its non-conductive bag, visually

inspect the device. If you notice any signs of damage, contact

Cabletron Systems Technical Support immediately.

CAUTION

The BRIM-E100 and the host hub are sensitive to static

discharges. Use a grounding strap and observe all static

precautions during this procedure. Failure to do so could result

in damage to the BRIM-E100 or the host hub.

book Page 1 Friday, April 19, 1996 9:53 AM

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 41 42

Žádné komentáře

Cabletron Systems BRIM-E100 Uživatelská příručka Strana 18