Cabletron Systems SmartSTACK 10 ELS10-26 Specifikace stáhnout pdf (Strana 83)

Configuring Workgroups Using SNMP

6-3

If ports are added to an existing workgroup, the index into the workgroup table

would be written to els10-27WorkGroupNumber. This would be obtained by first

reading all of the entries in the workgroup table. The name of the workgroup you

want to add ports to would be written to els10-27WorkGroupName.

If a workgroup was to be deleted, the index into the table and the workgroup

name would be used, as in the previous example, any value should be written to

els10-27WorkGroupPorts. However, a value of 4 would be written to els10-

27WorkGroupType to perform a delete.

NOTE

You must delete the Workgroup in its entirety. You cannot delete

part of a Workgroup.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 97 98

SmartSTACK ETHERNET 1
ELS10-27TX SUPPLEMENT 1
FCC NOTICE 4
INDUSTRY CANADA NOTICE 4
VCCI NOTICE 4
CABLETRON SYSTEMS, INC 5
PROGRAM LICENSE AGREEMENT 5
CABLETRON SYSTEMS LIMITED 9
DECLARATION OF CONFORMITY 12
CONTENTS 13
CHAPTER 4 VLAN MIB OBJECTS 14
Contents 15
ABOUT THIS SUPPLEMENT 17
GETTING HELP 18
DOCUMENT CONVENTIONS 19
RELATED DOCUMENTATION 20
CHAPTER 1 21
INTRODUCTION 21
1.2.1 IEEE 802.1Q Standard 22
1.3 802.1Q MODE ON ELS10-27TX 23
1.3.3 802.1Q Trunk Ports 24
Introduction 25
1.3.5 Switch Mode 26
1.3.7 Default Port VLAN ID 26
1.3.9 Enable GVRP 27
1.4 WORKGROUPS 28
1.5 DEFAULT GATEWAY 29
CHAPTER 2 31
ENHANCEMENTS TO LCM COMMANDS 31
2.3 LCM COMMAND SUMMARY 32
2.3.1 Subset of LCM Commands 32
2.3.2 LCM Command Syntax 33
2.4 BASIC LCM COMMANDS 34
2.4.1 Help 34
2.4.2 Erase 34
2.4.3 Exit or Logout 34
2.5 LCM COMMANDS 35
2.5.2 Route Command 36
2.5.3 Port Command 37
Enhancements to LCM Commands 38
2.5.4 Switch Command 39
2.5.5 Trap Control Command 40
2.5.6 VLAN Command 41
CHAPTER 3 43
Configuring VLANs Using SNMP 44
3.3 THE CONFIG EGRESS LIST 46
3.4 THE FILTER GVRP TABLE 48
3.5 THE STATIC MAC ENTRY 50
CHAPTER 4 51
VLAN MIB OBJECTS 51
4.2.3 Reset (VlanReset) 52
VLAN MIB Objects 53
4.2.6 VLAN (VlanConfigVlan) 54
4.3 CONFIGURATION ENTRIES 55
4.3.3 VID (VlanConfigVID) 56
4.3.5 IP (VlanConfigIP) 57
4.3.7 Name (VlanConfigName) 58
4.4 DEVICE ENTRIES 60
4.5 Egress Table 62
4.5.4 VID (VlanEgressVID) 64
4.5.5 List (VlanEgressList) 64
4.6 FILTER GVRP 66
4.6.3 VlanFilterGVRPIndex 67
4.7.3 VID (VlanStaticVID) 71
4.7.4 MAC (VlanStaticMAC) 72
4.7.5 Port (VlanStaticPort) 72
CHAPTER 5 75
5.1 OVERVIEW 75
Workgroup Alpha 76
Workgroup Default 76
Workgroup Superset 77
Workgroup Omega 77
5.3 LCM WORKGROUP COMMANDS 78
CHAPTER 6 81
6.1 OVERVIEW 81
CHAPTER 7 85
WORKGROUP MIB OBJECTS 85
7.1 OVERVIEW 85
7.2 WORKGROUPS USING SNMP 85
Workgroup MIB Objects 86
7.2.4 Table (WorkGroupTable) 87
7.2.5 Entry (WorkGroupEntry) 88
7.2.5.2 Name (WorkGroupName) 89
7.2.5.4 Type (WorkGroupType) 90
APPENDIX A 91
VIRTUAL LANS (VLANS) 91
A.1 VLANS AND FRAME TAGGING 91
A.2.1 VLAN ID 92
A.2.2 PORTS IN VLAN 93
A.2.3 VLAN EGRESS 93
A.2.4 VLAN ACCESS PORTS 93
ELS10-27TX VLAN Configuration 94

Komentáře k této Příručce

Žádné komentáře

Cabletron Systems SmartSTACK 10 ELS10-26 Specifikace Strana 83

Komentáře k této Příručce

Související produkty a manuály pro Sítě Cabletron Systems SmartSTACK 10 ELS10-26