Cabletron Systems SmartSwitch Router Specifikace stáhnout pdf (Strana 295)

Chapter 31 rip Commands

The Routing Information Protocol, Version 1 and Version 2, (RIPv1 and RIPv2) is the

most commonly used interior gateway protocol. RIP selects the route with the lowest

metric as the best route. The metric is a hop count representing the number of gateways

through which data must pass in order to reach its destination. The longest path that

RIP accepts is 15 hops. If the metric is greater than 15, a destination is considered

unreachable and the SSR discards the route. RIP assumes that the best route is the one

that uses the fewest gateways, that is, the shortest path. RIP V1 is described in RFC

1058 and RIP V2 is described in RFC 1723.

Command Summary

Table 20 lists the rip commands. The sections following the table describe the

command syntax.

Table 20: rip commands

rip add interface

| source-gateways | trusted-gateways

<hostname-or-IPaddr>

rip set broadcast-state always | choose | never

rip set check-zero disable | enable

rip set default-metric

<num>

rip set interface

<interfacename-or-IPaddr>

| all

[receive-rip enable | disable]

[send-rip enable | disable]

[metric-in

<num>

]

[metric-out

<num>

]

[version 1|version 2 [type broadcast|multicast]]

authentication-method [none|(simple|md5

key-chain

<num-or-string>

)]

rip set preference

<num>

rip show

<option-list>

rip start

rip stop

Chapter 31

1 2 ... 290 291 292 293 294 295 296 297 298 299 300 ... 361 362

Komentáře k této Příručce

Žádné komentáře

Cabletron Systems SmartSwitch Router Specifikace Strana 295

Komentáře k této Příručce

Související produkty a manuály pro Sítě Cabletron Systems SmartSwitch Router