Cabletron Systems T2015 Specifikace stáhnout pdf (Strana 46)

5-11

Samsung Electronics

System Outline

Service Manual

5.2.1 System Initialization

The system initialization process is carried out immediately after power on. The following tasks are performed.

1) Initialize ASIC

2) Initialize system variables

3) Initialize a virtual timer

4) Initialize fuser control

5) Initialize ADC

6) Set-up ITB HOME interrupt

5.2.2 Warm-Up

In the warm-up stage, the following tasks are performed.

1) Self Test

* System error check

* Cover open check

* Device (ITB, OPC, DEVE cartridge) check

* Heating error check

* Motion of motor and jam & paper empty check

* Check Feed and exit sensors. If paper is detected it is ejected. If the paper detection does not

clear a jam recovery is carried out and the paper drive unit is instructed to drive for the maximum

permitted paper length.

2) Heat Control

The heater control unit separately manages the temperature of the heat lamps.

* Target temperature (165°C)

* Temperature below 130°C - heat unit fully on,

* Temperature above 135°C temperature is controlled by reading the temperature value

every 10msec.

3) Cleaning

Transfer rollers, OPC and ITB are electrically and mechanically cleaned.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 227 228

Žádné komentáře

Cabletron Systems T2015 Specifikace Strana 46