Cabletron Systems SSIM-R8-02 Specifikace stáhnout pdf (Strana 293)

Enterasys Xpedition User Reference Manual 273

Configuring IPX Routing

To configure a VLAN with an IPX interface, enter the following command in Configure

mode:

Specifying IPX Encapsulation Method

The Enterasys Xpedition supports four encapsulation types for IPX. You can configure

encapsulation type on a per-interface basis.

• Ethernet II: The standard ARPA Ethernet Version 2.0 encapsulation, which uses a 16-

bit protocol type code (the default encapsulation method)

• 802.3 SNAP: SNAP IEEE 802.3 encapsulation, in which the type code becomes the

frame length for the IEEE 802.2 LLC encapsulation (destination and source Service

Access Points, and a control byte)

• 802.3: 802.3 encapsulation method used within Novell IPX environments

• 802.2: 802.2 encapsulation method used within Novell IPX environments

To configure IPX encapsulation, enter the following commands in Configure mode:

Configuring IPX Routing

By default, IPX routing is enabled on the XP.

Enabling IPX RIP

IPX RIP is enabled by default on the XP. You must first create an IPX interface or assign an

IPX interface to a VLAN before RIP will start learning routes.

Create an IPX interface for a

VLAN.

interface create ipx <InterfaceName>

address-mask

<ipxAddr-mask> vlan <name>

Configure Ethernet II encapsulation. interface create ipx <Interface Name> output-mac-

encapsulation ethernet_II

Configure 802.3 SNAP encapsulation. interface create ipx <Interface Name> output-mac-

encapsulation ethernet_snap

Configure 802.3 IPX encapsulation. interface create ipx <Interface Name> output-mac-

encapsulation ethernet_802.3

Configure 802.2 IPX encapsulation. interface create ipx <Interface Name> output-mac-

encapsulation

ethernet_802.2_ipx

1 2 ... 288 289 290 291 292 293 294 295 296 297 298 ... 393 394

Žádné komentáře

Cabletron Systems SSIM-R8-02 Specifikace Strana 293