Cabletron Systems SSIM-R8-02 Specifikace stáhnout pdf (Strana 51)

Enterasys Xpedition User Reference Manual 31

Hot Swapping a GBIC (ER16 only)

Removing the Switching Fabric Module

To remove the Switching Fabric Module:

1. Loosen the captive screws on each side of the Switching Fabric Module.

2. Pull the metal tabs on the Switching Fabric Module to free it from the connectors

holding it in place in the chassis.

3. Carefully remove the Switching Fabric Module from its slot.

Installing a Switching Fabric Module

To install a Switching Fabric Module:

1. Slide the Switching Fabric Module all the way into the slot, firmly but gently pressing

to ensure that the pins on the back of the module are completely seated in the

backplane.

Note: Make sure the circuit card (and not the metal plate) is between the card

guides. Check both the upper and lower tracks.

2. Tighten the captive screws on each side of the Switching Fabric Module to secure it to

the chassis.

Hot Swapping a GBIC (ER16 only)

The Gigabit Ethernet line cards have slots for GBICs that can be installed at any time. You

can hot swap the GBICs installed in the line cards, as well as the line cards themselves.

(For information on hot swapping line cards, see Hot Swapping Line Cards on page 26.)

WARNING The GBIC and the host gigabit Ethernet line cards

are sensitive to static discharge. Use an antistatic

wrist strap and observe all static precautions when

you remove or install a GBIC. Failure to do so could

result in damage to the GBIC and the host line card.

Always leave the GBIC in the antistatic bag or an

equivalent antistatic container until it is ready to be

installed.

Removing a GBIC from the Line Card

To remove a GBIC from its slot on the line card:

1. Remove any cables connected to the GBIC.

2. Locate the extractor tabs on either side of the GBIC.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 393 394

Žádné komentáře

Cabletron Systems SSIM-R8-02 Specifikace Strana 51