Cabletron Systems SSIM-R8-02 Specifikace stáhnout pdf (Strana 35)

100

101

Enterasys Xpedition User Reference Manual 15

Chapter 3

Using the CLI

This chapter provides information about the XP’s Command Line Interface (CLI). The XP

provides both a graphical user interface and a command line interface (CLI) to configure

and manage the XP. In this manual, example configurations show how to use the CLI

commands to configure the XP.

CLI commands are grouped by subsystems. For example, the set of commands that let

you configure and display IP routing table information all start with ip. Within the set of

ip commands are commands such as set, show, start, stop, configure, etc. The complete

set of commands for each subsystem is described in the Enterasys Xpedition Command Line

Interface Reference Manual.

Command Modes

The CLI provides access to four different command modes. Each command mode

provides a group of related commands. This section describes how to access and list the

commands available in each command mode and explains the primary uses for each

command mode.

User Mode

After you log in to the XP, you are automatically in User mode. The User commands

available are a subset of those available in Enable mode. In general, the User commands

allow you to display basic information and use basic utilities such as ping.

The User mode command prompt consists of the XP name followed by the angle bracket

(>), as shown below:

ssr>

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 393 394

Komentáře k této Příručce

Žádné komentáře

Cabletron Systems SSIM-R8-02 Specifikace Strana 35

Komentáře k této Příručce

Související produkty a manuály pro Sítě Cabletron Systems SSIM-R8-02